Subject: Drawing a donut



To draw a donut

   1   Do one of the following to choose Donut ():

   On the ribbon, choose Draw > Donut.

   On the menu, choose Draw > Donut.

   On the Draw toolbar, click the Donut tool.

   Type donut and then press Enter.

   2   Specify the inside diameter of the donut.

   3   Specify the outside diameter of the donut.

   4   Specify the center of the donut.

   5   Specify the center point to draw another donut, or choose Done to complete the command.

 

Inside diameter (A) and outside diameter (B).

The prompt box provides additional options for drawing donuts. For example, you can specify the width of the donut and two points on the diameter of the donut, or you can specify the width and three points on the donut. You can also draw a donut tan­gent to existing entities.

A donut can be a completely filled circle.
Donuts are completely filled if the inside diameter is zero.

3D Array
© Copyright 2022. BackToCAD Technologies LLC. All rights reserved. Kazmierczak® is a registered trademark of Kazmierczak Software GmbH. Print2CAD, CADdirect, CAD.direct, CAD Direct, CAD.bot, CAD Bot, are Trademarks of BackToCAD Technologies LLC. DWG is the name of Autodesk’s proprietary file format and technology used in AutoCAD® software and related products. Autodesk, the Autodesk logo, AutoCAD, DWG are registered trademarks or trademarks of Autodesk, Inc. All other brand names, product names, or trademarks belong to their respective holders. This website is independent of Autodesk, Inc., and is not authorized by, endorsed by, sponsored by, affiliated with, or otherwise approved by Autodesk, Inc. The material and software have been placed on this Internet site under the authority of the copyright owner for the sole purpose of viewing of the materials by users of this site. Users, press or journalists are not authorized to reproduce any of the materials in any form or by any means, electronic or mechanical, including data storage and retrieval systems, recording, printing or photocopying.